Garage Door Opener Installation In Few Easy Steps

The procedure of garage door opener repair is typically straightforward, though suppliers and parts may differ. Since these openers are normally set up by the consumer, installation directions are clear. Parts are classified to make sure easy setting up.

This process must just take a very little quantity of time and your opener will certainly be fully operational.

Put together the Opener

Set out all components as the instructions show. Parts are normally stamped or might consist of lettered stickers. The primary step is to put together the rail. Following you will certainly attach it to the opener’s electric motor head. When the opener has actually been entirely assembled, the last action is installation.

Affix the Rail to the Header


To do this step, you will certainly require an 8-foot ladder. Increase your garage and mark it at the highest point. Close the garage door.

At the website of the mark, measure up two inches. All-time low of the header brace will certainly be positioned below, over the center of the door. Place the header brace on at the second mark and secure it with two wooden lag screws.

With the electric motor end on the flooring and the rail inside the header brace, line up the opener setting up on the door. You will need to line up the openings on the rail with the header bracket. Glide a clevis pin via the bracket and rail to affix.

Mount the Motor


Area the ladder at the back of the door tracks, in the facility. Place the motor on the ladder. Gradually, elevate the garage door until it is available in contact with the door. As you continue to open the door, the electric motor setting up will be raised off the electric motor. When the door is completely open, place a 2×4 between the opener rail and the door.

To do your automatic garage door opener installation appropriate, you will certainly require to fasten the wall mounts to the motor head right into the ceiling packs. Utilizing the directions and hangers offered, connect them to the ceiling with lag screws. After attaching the hangers, raise the electric motor head and screw it to the ceiling wall mounts.

Posted in Uncategorized

Leave a Reply

Your email address will not be published. Required fields are marked *